Is there any deviation in the hole position of the automatic screw locking machine?

Now the workshop is automatic equipment work, automatic locking screw machine is not only high production efficiency, at the same time the equipment cost is relatively low, help many production factories to save a lot of labor costs, some netizens are curious about the automatic locking screw machine equipment on the hole location is no deviation? Or how much does it have to be off?Today I will give you the answer to this question.

What's the hole deviation of automatic screw locking machine? Now automatically lock screw machine for hole position deviation requirements within 0.02-0.05mm, if the hole position deviation is big, can appear when the lock screw machine pay lock slanting, lock bad and so on, many kinds of uncertainty, now most of the product process is basically fixed, is unlikely to change process, if the hole position deviation is big improvement, only access to the visual positioning system.

General automatic locking screw machine and visual fixed system can solve the screw deviation lock can't pay problem, but this kind of screw machine and CCD system, equipment will be slightly expensive than the ordinary screw machine, Visual positioning automatic locking screw machine can automatically correct the hole location lock pay, at the same time can also be online real-time torque monitoring, support scanning code start, can be connected with the factory's MES system, convenient data management division and headquarters.

The above is the full automatic screw locking machine hole positioning deviation content.

http://www.yuccitech.com/index.php?id=12